LIQUID FILLING

POUCHING & BAGGING

TUBE FILLING

TABLET COUNTING

POWDER FILLING

MONOBLOCK

CAPPING & RETORQUING

LABELING

The Aesus Economy range of Neck Banding/Sleeving machines are very compact and affordable.

Speeds 100/min on reasonable sized sleeves.
Faster on Neck bands (200 per minute).

Sleeves up to 4.375 inch dia (100mm) (170mm) flat width.

Apart from inherently well designed machinery including oversized supports, stainless steel panels, optional safety guarding, compact footprint and other excellent features too numerous to mention, ShrinkBanders have certain very exclusive advantages listed below.

Mandrel application Bands or Sleeves are applied to the container, directly from the mandrel. This means there is no secondary side transfer or vacuum cups or other movement. Sleeves go right on the container.

Static Electricity: As the bands are not released until they are on the container static electricity has virtually no effect. If you have very short bands and lots of static then our proprietary band tacker can be enabled right at the application station to ensure the band stays put.

Band Tacker: Our own optional proprietary single or dual band tackers can enabled to tack the band to the container. This is activated directly from the control panel, and saved away as a recipe to be recalled for subsequent use once setup correctly.

Large Bands: The larger the container diameter the better our machines stand up against the competition because we control the band right onto the neck, and then if needed tacked. Short Bands Very short bands (3mm or so) can be applied by our ShrinkBanders, where other machines lose total control.

Dial in any length at the control panel using our unique servo band feed mechanism. Recall recipes for subsequent set ups. Print registration Both clear and printed band material can be run on the same machine with the optional photo registration device.

Changeover: new products can be set up quickly and easily. The time saved adds up rapidly... helping pay for the machine over and over.

Close sizing of Mandrel,
band and container
As we apply directly from the Mandrel we can have a band that more closely fits the container, thereby
saving band material cost, and giving better final shrink characteristics. The closer the band fits the container the smaller percentage of shrink needed. No suction cups .

Direct application again means that neither suction cups nor vacuum is needed to hold the band. Neither humidity, dust, nor worn suction cups have any
effect on the machine.

Compact: The Shrinkbander takes up half the space of others.

 

Intermediate Shrink Labeler

Uses a servo motor instead of an air cylinder to control the Sleeve length. This means that the sleeves can be virtually any length, just dial-in the length required, or utilize the optional print registration device. Like the Eco Shrink Labeler the sleeves are cut off with a pneumatically-operated knife and sleeves in diameter from less than ½" up to 6" (or more) in diameter can be applied.

The Delta Shrink Labelers have speeds of up to 120 per minute on typical sleeves and higher speeds 200/min are be possible for shorter sleeve lengths – for example, neckbands. The speed attainable is a combination of the container characteristics and the sleeve length required.